Car amp hookup kit - All Car Amplifiers - Car Amps at Sonic Electronix


• Un-attach the cable clevis at the rear axle
• Un-attach the cable clevis at the hand-brake lever
• Remove the old cable from the car
• Unsolder the brass end from the cable at the gearbox end. Remove the clevis and on a +4 the transmission through bolt from the cable.
• On the new cable remove the clevis and brass end and discard the brass end
• On a +4 install the transmission through bolt onto the new cable
• *Note* The new cable retainer has a small ball bearing in the bottom of the hole. If you remove the retaining bolt make sure that the ball does not fall out.
• Install the new cable retainer into the clevis from the new cable and reinstall the clevis with the cable retainer onto the cable making sure that the cable protrudes through the retainer a small amount and clamp the retainer bolt down hard to lock the cable in place.
• Reinstall the cable into the car attaching first the cable to the hand-brake lever
• Reattach the cable at the rear axle
• Use the adjuster in the rear axle so that the hand brake works properly.


Car amp hookup kit

Car amp hookup kit